Luban LCD

Simple Testing and Move Around

After complete all above configurations, we could do a simple testing now. Remember to choose correct COM port of your RAMBo and click upload, uploading success as shown below:

Duinopeak Luban LCD - 3D打印控制面板 + RAMBo主控使用指南

硬件准备

为了防止静电损害,在动手前注意释放一下你身上的静电,触摸一下大的金属物品,比如金属水龙头或者干脆洗个手:)

好了,打开你的3D打印套件, 此教程使用的RAMBo版本为1.1b,需要正确设置USB模块的供电方式。默认出厂为外部电源供电,但是这里为了方便我们需要使用USB电源供电,将RAMBo的USB供电跳线设置为USB供电一端,如下图所示:

然后把Luban LCD Console和RAMBo主控板连接起来,如下图所示:

Prepare hardware and software

Prepare Hardwares

In order to prevent damage from electrostatic discharge, do note before releasing your electrostatic, touch metal objects,like metal faucet or washing hands, :)

OK, open your 3D printing Kit, this tutorial uses the version of RAMBo 1.1b, you need to correctly set up the power supply jumper to USB side, because we use USB supply in this tutorial. As shown below:

Getting Started with Duinopeak Luban 3D Printer Kit

Then connect the Luban LCD Console and the RAMBo Controller board, as shown below:

 

Subscribe to Luban LCD